Finishing Specs

When requesting a quote for laser cut parts from Lakewood Fab Tech, please reference the following sheet. Finishing specs are offered for Aluminum, Carbon Steel, and Stainless Steel, and will slightly affect your pricing.

Please define which of these finishes you expect prior to placing an order if at all possible.

 Picture Ref. #  Finish Details SPEC 1  SPEC 2 SPEC 3
 N/A Finish Offered For Stainless, Carbon Steel, Aluminum Stainless, Carbon Steel, Aluminum Stainless, Carbon Steel, Aluminum
 N/A  Deburring Provided?  None  None  Full Deburr
 1  Sharp Edges  Likely  Some  None
 2  Grind Marks None (No Deburring)  Some Minimal
 3 Removal of Laser Tab & Laser Slug  None  Yes  Yes

Stainless Steel 

Any deburring for stainless steel is done by our Lissmac SBM-L 500 by default, but is size dependent.

  • Minimum Size: 2in wide x 6in long (no minimum height restrictions)
  • Maximum Size: 60" wide x 2" tall (no maximum length restrictions)

For parts that do not fit the Lissmac, a grinder with flap disc will be used for deburring

(Click on an example below to expand)

SPEC 1

SS - SPEC 1

SPEC 2

SS - SPEC 2

SPEC 3

SS - SPEC 3


Carbon Steel 

A grinder with flap disc will be used for deburring

(Click on an example below to expand)

SPEC 1

CS - SPEC 1

 

SPEC 2

CS - SPEC 2

 

SPEC 3

 


Aluminum 

A grinder with flap disc will be used for deburring

(Click on an example below to expand)

SPEC 1

 

SPEC 2

AL - SPEC 2

 

SPEC 3